Vortech 1997-2001 5.2L/5.9L Durango/Dakota - Manual (Page 12)

P/N: 4CE020-010
© 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
18AUG00 V 2.1
(Dodge 5.9L Durango/Dak-2)
2
2. OIL DRAIN, cont'd.
G. Thoroughly clean the threaded area. Apply a
small amount of silicone sealer to the new threads.
Apply more sealer to the male threads of the 3/8"
NPT x 45
°
street elbow and secure in the hole.
Position the fitting so that it points up toward the
top/front of the vehicle at approximately a 45
°
angle (see Figure 2-c ). Make sure a seal is formed
all around the fitting. Thread the 3/8" NPT x 1/2"
barb fitting into the 45
°
street elbow using a small
amount of pipe sealer.
H. Drain engine oil and change filter.
I.
The drain hose will be attached to the fitting in later
steps. If your installation is going to be over
several days we suggest that you cover the fitting
to protect it from dirt.
J. Reinstall front wheel and torque lugnuts to proper
specifcations.
45
°
ANGLE
UPWARD
A. Attached the new air filter to the supplied
filter as shown and secure with a hose
clamp.
B. Place the filter assembly into the right side
fenderwell and mark hole locations to be
drilled for mounting. Make sure that the
filter mount assembly is sitting on a flat
area of the inner fender before marking
hole locations. (See
Figure 3-a .)
C. Punch and drill the three hole locations.
D. Mount the filter assembly to the inner
fender using the supplied sheet metal
screws (see
Figure 3-b ).
3. AIR FILTER INSTALLATION (1997-99 Dakota/Durango only)
Figure: 2-c
Figure: 3-a
Figure: 3-b