Vortech 1997-2001 5.2L/5.9L Durango/Dakota - Manual (Page 14)

P/N: 4CE020-010
© 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
18AUG00 V 2.1
(Dodge 5.9L Durango/Dak-2)
E. Secure the plate and tensioner as an
assembly to the cast bracket. (See
Figure 4-c .)
F. Remove the right side exhaust mani-
fold heat shield. Remove the second
bolt (from the front) mounting the mani-
fold to the head. Attach the supplied
support strut between the super-
charger mounting plate and the sec-
ond exhaust manifold stud. Secure
with the supplied stainless steel bolt
(see
Figure 4-b ).
G. Attach the loose ground connection(s)
from the main harness (near the su-
percharger mounting bracket) to the
existing alternator mounting bolt and
secure. (See
Figure 4-d .)
4
4. MAIN MOUNTING BRACKET AND PLATE, cont'd.
Figure: 4-c
Figure: 4-b
Figure: 4-d
1997-99 Dakota/Durango
NOTE: Slight bending of the factory
3/8" aluminum air conditioning
line (running to the firewall) is
required before mounting plate
can be installed (see photo be-
low).
EXHAUST
MANIFOLD
.60 SPACER
SUPPILED 5/16" BOLT
(REMOVE FACTORY
BOLT/STUD)
HEAT
SHIELD
.25 SPACER
VORTECH
SUPPORT
SUPPORT STRUT DETAIL
5/16” WASHER
ATTACH TO
EXHAUST MANIFOLD
3/8-16 X 1.0
3/8-16 X 3.0
3/8-16 X 1.0
3/8-16 X 3.0
3/8-16 X 3.75
GEARCHARGER
MOUNTING PLATE
MAIN MOUNTING
BRACKET
SUPPORT
STOCK TENSIONER
5/16-18 X 3.5
3/8-16 x 1"
3/8-16 x 3"
3/8-16 x 3-
3/8-16 x 1"
SUPERCHARGER
MOUNTING PLATE
MAIN
GROUND TO ALTERNATOR
MOUNTING BOLT
3/8-16 x 3-3/4" -
(BOLT MUST BE
INSTALLED
THROUGH PLATE
BEFORE SPRING
TENSIONER IS
MOUNTED.)
STUD MAY
NEED TRIMMING
3/8-16 x 3"
MAIN HARNESS
MAIN
MOUNTING
BACKET
ATTACH TO EXHAUST
MANIFOLD
SUPPORT
STOCK TENSIONER
5/16-18 x 3-3/4"