Vortech 2011-2012 6.4L Hemi Challenger User Manual
Page 20
P/N: 4CL020-020 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
10
7.
aIR INLET INSTaLLaTION, CONT’D
F.
Remove the hood latch cable clip and move to
the side to be reattached to the inlet duct-
mounting bracket in a later step.
G. Remove the 3/8” power steering hose from the
drivers side of power steering cooler and from
the reservoir. Set aside; it will not be used.
H.
Locate the 30-inch piece of power steering hose
that is provided. Install the hose clamps from
the factor power steering hose.
I.
Route the new power steering hose down and
behind the core support between the radiator
and the core support. (See Fig 7-d)
J.
Attach the inlet duct to the inlet of the super-
charger and secure with the hose clamp previ-
ously installed.
K.
Reinstall the 15 mm headed bolt removed in an
earlier step. Attach the hood latch cable to the
bracket supporting the inlet duct. (See Fig 7-e)
L.
Attach the crank case breather hose to the 90º
plastic fitting on the end of the air filter. (See Fig
7-f)
M. Route the breather hose through the round hole
located in the inner fender to the crank case
breather fitting on the intake manifold.
N.
Check the power steering fluid level and re-fill
as necessary.
O. Re-install headlight, hardware and connectors.
Fig. 7-d
Fig. 7-e
Fig. 7-f