Vortech 2011-2012 6.4L Hemi Challenger User Manual

Page 14

P/N: 4CL020-020 v1.0, 12/02/2014

COOLaNT & POWER STEERING RESERVOIR REPLaCEMENT

A. If there is still coolant present in the tank, remove

the coolant reservoir cap & drain the coolant from

the radiator drain port located on the bottom of

the radiator. For ease of installation, only drain

enough to empty the coolant reservoir. Once

drained, remove the factory-installed coolant

reseroir & install the supplied coolant reservoir

& refill. (See Fig. 4-a)

B. Remove the power steering fluid reservoir cap

& drain the power steering fluid by removing the

rubber line directly below the reservoir. Once

drained, remove the threaded line from the

power steering pump & set aside, then proceed

to remove the 3 screws securing the power

steering pump to the cylinder head. Additional

fittings will be installed in a later step. (See Fig.

4-b)

C. Locate the supplied power steering fluid reservoir

& install it onto the coolant reservoir as shown

in Fig. 4-a. Locate the rubber line previously

removed from the power steering reservoir &

install it onto the supplied power steering fluid

reservoir. Using the supplied large-diameter

power steering line, attach it to the bottom of

the supplied power steering fluid reservoir & set

aside. The other end of the large-diameter hose

will be installed in a later step. Secure both lines

with the supplied hose clamps. (See Fig. 4-c)

NOTE: For proper installation, the factory coolant reservoir &

power steering fluid reservoir will need to be replaced

with the included old-style reservoirs.

Fig. 4-b

P/S LINES

Fig. 4-a (Supplied Reservoirs)

COOLANT RESERVOIR

Fig. 4-c

SUPPLIED P/S

RESERVOIR

SUPPLIED

P/S LINE

FACTORY

P/S LINE

P/S FLUID RESERVOIR