Vortech 2011-2012 6.4L Hemi Challenger User Manual

Page 15

P/N: 4CL020-020 v1.0, 12/02/2014

SUPERCHaRGER MOUNTING PLaTE INSTaLLaTION

A. There are (3) 10mm headed screws securing the

reservoir to the pump. (2) screws are located on

the back side of the power steering pump & (1) is

located on the pulley-side of the power steering

pump (not pictured). Remove these (3) screws,

then remove the power steering fluid reservoir

from the power steering pump. (See Fig. 5-a)

B. Carefully remove the o-ring from the previously

removed power steering fluid reservoir & transfer

it over to the supplied power steering adaptor

block. Be sure not to damage the o-ring. (See

Fig. 5-b)

C. Locate the supplied power steering fittings & clock

them as shown. Use a light amount of pipe seal-

ant on the threads. (See Fig. 5-c)

D. Locate the supplied mounting bracket assembly.

Loosely attach the steel bracket to the back of the

primary mounting plate. Attach the supercharger

mounting plate to the primary mounting plate using

the supplied M8x90mm bolts and spacers. (See

Fig. 5-d)

Fig. 5-b

P/S ADAPTOR

BLOCK

FACTORY O-RING

SUPPLIED FITTINGS

(ATTACHED IN A LATER STEP)

Fig. 5-c (Clocking Reference)

Fig. 5-a

RESERVOIR BRACKET

SCREWS

Fig. 5-d

SUPERCHARGER

MTG PLATE

PRIMARY MTG

PLATE

STEEL

BRACKET

P/S PUMP

P/S ADAPTOR

BLOCK ASSY.