Two Notes VB-101 - Manual (Page 48)

Specifications
4 Technical data
Designation Characteristics
Speaker Input
Jack 6.35mm (1/4") unbalanced (TS, Tip/Sleeve)
Maximum input voltage: 50 Volts AC (36 dBu)
Security load: 160 Ohms / 10 Watts
ANALOG Input
XLR balanced/unbalanced (relay switch)
Maximum input level: 14 dBu
Input impedance: 10 kOhms
Loadbox
Resistive load, nominal impedance: 8 Ohms
Maximum admissible power: 150 Watts (assuming proper ventilation)
Cooled by temperature-controlled fan
High Impedance mode if a cabinet is connected to the THRU output (loadbox discon-
nected).
Speaker Thru Jack 6.35mm (1/4") unbalanced (TS)
Pre Simulation Output
XLR balanced
Impedance: 100 Ohms
• (no load, balanced): 8.1 dBu
• (10 kOhm load, balanced): 8 dBu
• (no load, unbalanced): 2.1 dBu
• (10 kOhm load, unbalanced): 1.9 dBu
Noise: less than -98 dBu from 20 Hz to 20 kHz
Post Simulation Output
2 x XLR balanced
Impedance: 100 Ohms
Maximum output level:
• (no load, balanced): 10.7 dBu
• (10 kOhm load, balanced): 10.5 dBu
• (no load, unbalanced): 4.7 dBu
• (10 kOhm load, unbalanced): 4.5 dBu
Noise: less than -94 dBu from 20 Hz to 20 kHz
Headphones Output MONO out, Jack 6.35mm (1/4") balanced (TRS)
48 Two Notes Audio Engineering Torpedo VB-101