Two Notes VB-101 - Manual (Page 43)

Part 6
MIDI Implementation
Your TORPEDO VB-101 can be controlled by MIDI messages (PROGRAM CHANGE and CONTROL
CHANGE) sent by a device connected to the "MIDI IN" input (number 6 in figure 3.2). The controlling
device can be a foot controller, a keyboard, or a personal computer.
To learn how to send MIDI messages, please refer to the manual of your controller.
The MIDI messages are transmitted to every linked machine. To filter
MIDI data received by the machine, you should configure the TOR-
PEDO VB-101 to either be on a single (1-16) channel, or on "ALL" chan-
nels. Please refer to section 4.3.
If you have several products communicating with a MIDI connection, you can use the "MIDI
OUT/THRU" output of the TORPEDO VB-101, which mirrors every MIDI message coming in through the
"MIDI IN" input.
1 PROGRAM CHANGE (PC)
Every preset in the TORPEDO VB-101 is identified by a corresponding program number. Preset 00 of
the TORPEDO VB-101 corresponds to the MIDI PC 01. You can address the 100 presets (from 00 to 99),
with MIDI PC 01 to MIDI PC 100. So you can access every preset by sending a PROGRAM CHANGE
message with the appropriate number.
2 CONTROL CHANGE (CC)
The following table indicates the CONTROL CHANGE numbers for every TORPEDO VB-101 param-
eter, as well as their range and behavior.
Two Notes Audio Engineering Torpedo VB-101 43