Two Notes VB-101 - Manual (Page 31)

Configuring and using TORPEDO VB-101
4.2 Sync
• Sync: The TORPEDO VB-101 can be synchronized with an
external clock ("Wordclock") or with input digital signals
("S/PDIF" or "AES/EBU"). If you select an external clock sync,
the "Lock" indication in the lower left corner of the PER-
FORM screen will show together with the detected fre-
quency ("Output Freq.") in the SETUP menu when the TOR-
PEDO VB-101 is actually locked to the external signal.
• Output Freq.: Indicates the frequency of the TORPEDO VB-101 digital outputs. Analog outputs
always run at 192 kHz.
4.3 Midi
• Channel: Select here the MIDI Channel you want the TOR-
PEDO VB-101 to respond to. When "All" is selected, the TOR-
PEDO VB-101 responds to all the channels (omni mode). All
the signals received at the MIDI input are sent back through
the "MIDI OUT/THRU" output.
• Control Change: Select whether or not the TORPEDO VB-101
should respond to CONTROL CHANGE messages.
• Program Change: Select whether or not the TORPEDO VB-101 should respond to PROGRAM
CHANGE messages.
4.4 System
• Brightness: Set the brightness level of the display screen.
• Fan Control: Control the behavior of the cooling fan. We
recommend using the "Auto" mode, in which the fan’s speed
is controlled by the internal temperature.
4.5 Device ID
• Device ID: This menu lets you give an identifying name to
your machine. If you wish to use the TORPEDO Remote soft-
ware to control several different machines simultaneously
USB-connected to the same computer, you will have to give
each machine a different Device ID. Move through the al-
phabet using the "NAVI" knob and select the letters with
"OK".
Two Notes Audio Engineering Torpedo VB-101 31