Taser X2 - Manual (Page 28)

28 Chapter 3 Features
Configuring the X2 CEW and Viewing the System Status
Remove the Smart cartridges from the X2 CEW before configuring the CEW or viewing its status. See the
Unloading section in this manual for more information.
Before using an X2 CEW, set the LASER settings and LED flashlight (if necessary). You also can view status
information about your CEW on the CID.
Setting the Sighting Options
You can set up your X2 CEW to turn the LED flashlight and LASER sights off or on, in several configurations.
Follow these steps:
1 Point the X2 CEW in a safe direction.
2 Shift the safety switch to the down (SAFE) position.
3 Remove the Smart cartridges from the X2 CEW. See the Unloading section in this manual for more information.
4 Press and hold the selector switch until the main menu displays.
5 Press the left ARC switch to open the sighting options.
6 Press the right ARC switch to select the needed setting.
OO – Flashlight OFF and LASER OFF
LO – LASER ON and flashlight OFF
OF – LASER OFF and flashlight ON
LF – LASER ON and flashlight ON
7 Press the selector switch to return to the main menu.
8 If you are done configuring the X2 CEW, press the selector switch again to exit. Or, to set other options, use
the right ARC switch to scroll through the menus.
Viewing the System Information
To view information about the X2 CEW system (for example, the serial number, date, time, and software revision
level), follow these steps:
1 Point the X2 CEW in a safe direction.
2 Shift the safety switch to the down (SAFE) position.
3 Remove the Smart cartridges from the X2 CEW. See the Unloading section in this manual for more information.
4 Press and hold the selector switch until the MAIN MENU displays.