3 add the generic point io module – Spectrum Controls 1734sc-IF4U User Manual
Page 28

3-6
Point IO™ 4 Channel Universal Analog Input Module
User’s Manual Pub. 0300266-01 Rev. A
3.3.3 Add the Generic Point IO Module
After adding the remote Ethernet communication module, the 1734 Generic Module must
be added. The following steps must be followed to add the 1734 Generic IO Module.
1.) Select a New Module for the I/O Configuration.
2.) Select the module type from the Select Module Type pop-up.
Right-click on the
remote communication
Select New Module
Name the module
Select the comm. format
Enter IP address of ENBT
Select the chassis size
Select electronic keying level
Click OK
Select the module revision
level