SkyRC e6650 - Manual (Page 24)

- 23 -
DISCHARGING OF THE PB BATTERY
PROGRAM SELECT
SAVE DATA
SAVE [01] NiMH
14.4V 3000mHh
NiMH CHARGE At*
CUR LIMIT 5.0A
NiMH DISCHARGE*
1.0A 11.0V
NiMH CYCLE *
DCHG>CHG 3
Save ...
DATA STORAGE PROGRAM
INC DEC
INC DEC
INC DEC
- +
INC DEC
- +
INC DEC
- +
INC DEC
- +
INC DEC
- +
Batt type
Stop
Start
Enter
Start
Enter
Start
Enter
‘>3 seconds’
‘>3 seconds’
Voltage Data
number
Capacity
Type of
battery
For your convenience, e6650 has a data storage and load program.
It can store five battery data representing the respective specifications
of batteries. You can call back the data when charging or discharging
without setting up the program again. Press START/ENTER key to
make it blink, and use INC or DEC to set up the parameter.
Setting of the parameter in the screen will
not affect the charge and discharge process.
They just present the specification of the
battery. The example is NiMH battery pack,
including 12 cells, the capacity is 3000m Ah.
Set up the charge current in the manual
mode, or current limit in the auto mode.
Press INC and DEC key simultaneously to
make the current field blink to switch the
charge mode.
Set up the discharge current and final voltage.
Set up the charge/ discharge sequence and
cycle number.
Saving the data.