SkyRC e6650 User Manual

Page 13

- 12 -

INITIAL PARAMETER SETUP (USERS SET UP)

As default this charger will be set to typical user settings when it is

connected to AC 110-240V or DC 11-18V for the first time. The

screen displays the following information in sequence and the user

can change the parameter on each screen.

e6650 recognize the cell count of Lithium battery

automatically at the beginning of charge or

discharge process to avoid from erroneous

setting by user. But deeply discharged battery

can be perceived incorrectly. To prevent the

error, you can set the time term to verify the cell

count by the processor. Normally, 10 minutes

are enough to perceive the cell count correctly.

For the battery of larger capacity, you may

extend the time term. But if you set the time

term to long for the battery of smaller capacity,

the charge or discharge process can be finished

within the time term with the erroneous cell count.

This may cause the fatal result. If the processor

USER SET
PROGRAM->

LiFe
V.Type 3.3V

LiPo/LiIo/LiFe
CHK Time 10min

INC

DEC

INC

DEC

User setup starting screen.

The screen displays the nominal voltage of

Lithium battery. There are three kinds of Lithium

battery: LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V).

This is very important so you have to check the

battery carefully and set it up correctly. If it is

different from correct value the battery may be

exploded during charge process.

If you need to alter the parameter value in the program, press

“Start/Enter” key to make it blink then change the value with “INC”

or “DEC” key. The value will be stored by pressing “Start/Enter” key

once.

- +