SkyRC e6650 - Manual (Page 18)

- 17 -
FAST CHARGING OF LITHIUM BATTERY
LiPo FAST CHG
2.0A 11.1V(3S)
INC DEC
- +
INC DEC
- +
Batt type
Stop
Start
Enter
Start
Enter
‘>3 seconds’
R:3SER S:3SER
CONFIRM(ENTER)
Li3s 2.0A 12.59V
FAS 022:43 00682
Number
of cells
Charging
time
Charging
current
Current
voltage
battery
Supplied
capacity
Charging current will become lower when it progress to the end of
charging. A specific CV process will be reduced to end the charging
process earlier. In fact, the charging current will goes to 1/5 when the
charging process comes to 1/10. Charging capacity will be little
smaller than normal charging, but charging time will be shortened
accordingly.
CHARGING LITHIUM BATTERY IN THE FAST CHARGE MODE
FAST CHARGING OF LITHIUM BATTERY
The value on the left side of the second lines
sets the charge current. The value on the
right side of the second lines sets the battery
pack's voltage. After setting current and
voltage, press STAR/ENTER for more than
3 seconds to start the process.
This displays the number of cells you set up
and the processor detects. “R” shows the
number of cells detected by the charger and
“S” is the number of cells set by you at the
previous screen. If both numbers are
identical you can start charging by press
START/ENTER button. If not, press BATT
TYPE/STOP button to go back to previous
screen to carefully check the number of cells
of the battery pack before going ahead.
This screen shows the real-time status during
charge process. Press BATT TYPE/STOP
key once to stop the charge process.