SkyRC e6650 - Manual (Page 10)

- 09 -
WARNING AND SAFETY NOTES
Have you checked that all connections are firm and secure?
Make sure there are no intermittent contacts at any point in the
circuit.
Charging
During charge process, a specific quantity of electrical energy is
fed into the battery. The charge quantity is calculated by
multiplying charge current by charge time. The maximum
permissible charge current varies depending on the battery type
or its performance, and can be found in the information by the
battery manufacturer. Only batteries that are expressly stated to
be capable of quick-charge are allowed to be charged at rates
higher than the standard charge current.
Connect the battery to the terminal of the charger: red is positive
and black is negative. Due to the difference between resistance
of cable and connector, the charger can not detect resistance of
the battery pack, the essential requirement for the charger to
work properly is that the charge lead should be of adequate
conductor cross-section, and high quality connectors which are
normally gold-plated should be fitted to both ends.
Always refer to the manual by the battery manufacturer pertaining
to charging methods, recommended charging current and
charging time. Especially, the Lithium battery should be charged
according the charging instruction provided by the manufacturer
strictly.
Attention should be paid to the connection of Lithium battery
especially.
Do not attempt to disassemble the battery pack arbitrarily.