Rocktron Intellipitch - Manual (Page 7)

4
8 STORE button
This button is used to store values into the Intellipitch memory when modified. See
Chapter 8, section C, "Storing Modified Parameters" for more information.
9 PARAMETER SELECT control
When monitoring parameter values, this control will scroll through the available
parameters under the current effect heading.
In the "TITLE EDlT" function, this control will scroll through the available characters
in the title that may be edited.
10 FUNCTION SELECT control
This control allows access to each of the primary functions of the Intellipitch. Once a
specific function has been selected, the parameters for the function are accessible
through the PARAMETER SELECT control. Depending upon which configuration the
current preset is created from, these functions may include:
Mixer HUSH Reverb Delay
Ducker Voice/Delay Intelligent Shift Reverse Shift
Title Edit Controller Assign Program Mapping MIDI Channel
Factory Restore MIDI Dump/Load Tuner Config Select
11 BYPASS button
When pressed, the LED is lit and all effects are bypassed.
12 INPUT LEVEL meter
These LEDs provide visual indication of the peak level of the input signal. For the
optimal signal-to-noise ratio, it is best to adjust the input level so that the last LED
(0dB) is rarely lit. This will guard against the possibility of overdriving the unit.
13 INPUT LEVEL control
This control adjusts the unit's gain to match the signal level at the input of the
Intellipitch. The gain can be adjusted from -12dB to +12dB. Use the INPUT LEVEL
meter to determine the setting of this control.
14 CLIP L.E.D.
When lit, this L.E.D. indicates that the final analog output is being overdriven because
the Effects Level, Direct level, and Output Level control are set too high. If this occurs,
reduce these levels until this L.E.D. does not light.
15 OUTPUT LEVEL control
This control is used to adjust the output level of the unit and may be adjusted from zero
signal to a small amount of gain.
16 REFERENCE LEVEL switch
This switch determines the output range of the unit and may be set at either -10dB or
+4dB. When using professional studio equipment providing a nominal input level of
+4dB, it is recommended that the +4 setting on the Intellipitch be used for best results.
If connecting the Intellipitch to a high sensitivity input, such as the input to a guitar
amp, the -10 setting should be used.