Rocktron Intellipitch - Manual (Page 58)

55
This entire process is repeated 7 times for a total of 8 controllers (NUMB2, NUMB3, etc.). To
exit Controller Assign at any time, turn the PRESET or FUNCTION SELECT controls. Only
those changes that have been stored will be saved after exiting Controller Assign.
Also, a lower limit may be selected which is greater than the upper limit. This will invert the
response of the controller. For example, the toe position of an expression pedal would provide
the minimum value while the heel position would provide the maximum value.
Notes
Step 11 Turn the PARAMETER SELECT control for the last parameter—Controller Lower Limit.
LLIM C1 XXX
Step 12 Use the PARAMETER ADJUST control to select the parameter value which the controller is not
to fall below.
LLIM C1 -10.0
After choosing a lower limit parameter value, press the STORE button to save it. "STORED"
will flash briefly on the display. Step 13
STORED