Rocktron Intellipitch - Manual (Page 66)

63
Reloading the user memory from a sequencer:
Connect the MIDI OUT of the sequencer to the MIDI IN on the Intellipitch with a standard
MIDI cable. Step 1
Turn the FUNCTION SELECT control on the Intellipitch fully clockwise to the "MIDI DUMP/
LOAD" position. Step 2
MIDI DUMP LOAD
Turn the PARAMETER SELECT control to the "LOAD USER DATA" position. The
Intellipitch is now ready to receive the user data from the sequencer. Step 3
LOAD USER DATA
Play back the user data previously recorded on the sequencer. The Intellipitch will display the
data strings as it is storing them. The data string and "LOADED" will appear on the display.
After all the user data has been loaded the Intellipitch will display "USER DATA LOADED".
The entire procedure will take approximately 3 minutes to complete. Step 4
USER DATA LOADED
Do not play back data from the sequencer faster than it was recorded, as errors may occur.
Errors may also occur if any knob is turned or any button is pressed before the message “USER
DATA LOADED”appears.