Martin Christ Epsilon 2-10D LSCplus - Manual (Page 32)

Freeze-dryer EPSILON 2-10D LSCplus
4 Storage and transport
32
Version 04/2013, Rev. 1.5 of 16/12/2014 • sb
Translation of the original operating manual
Pos: 85 / 200 Christ /36 1 GT -BA La bor -Pilot (PROJEKTE )/Epsilon 2- 10D LSC plus Sta nda rd/0 40 Lage ru ng u nd Tra nspo rt/0 40- 004 0 Ve rpack ung E2-1 0D @ 25\m od_ 140 498 489 431 9_68 .docx @ 1 864 07 @ 2 @ 1
4.4 Packaging
The freeze-dryer is packaged in a wooden crate.
• After opening the packaging, take out the accessories.
• Remove the packaging material.
• Remove the side walls of the crate.
• Lift the freeze-dryer upwards with a lifting device.
CAUTION
The freeze-dryer Epsilon 2-10D LSCplus weighs approx. 750 kg!
CAUTION
The centre of gravity of the freeze-dryer is off-centre!
• Retain the packaging for any possible future transport of the freeze-
dryer.
Pos: 86 / 010 Unive rsalm odul e/Le erzeil e @ 0\mo d_1 202 116 244 500 _0.d ocx @ 114 @ @ 1
Pos: 87 / 200 Christ /36 1 GT -BA La bor -Pilot (PROJEKTE )/Epsilon Stan dar d/04 0 La ger ung un d T rans por t/04 0-0 050 T rans por tsiche run gen E psilon @ 25\ mo d_14 049 846 137 92_ 68.d ocx @ 185 637 @ 2 @ 1
4.5 Transport safety devices
The following transport safety devices must be removed prior to start-up:
• Remove the polystyrene blocks between the shelves.
• Unscrew the sealing cap of the expansion vessel of the heat transfer
medium and install the drying cartridge (adsorption filter) (see chapter
Fehler! Verweisquelle konnte nicht gefunden werden. - "Fehler!
Verweisquelle konnte nicht gefunden werden.").
• Install t he vac uu m sen sor (see cha pte r 0 - "
").
NOTE
Prior to any transport, the transport safety devices must be reinstalled.
Pos: 88 / 010 Unive rsalm odul e/Seite nwechs el @ 0 \mo d_1 202 116 244 312_ 0.d ocx @ 105 @ @ 1