Martin Christ Beta 2-8 LDplus - Manual (Page 14)

14 General Information Operating Manual Freeze Dryer BETA 1-8 LDplus / BETA 2-8 LDplus
1.6.2. CAUTION! Solvents!
Acidic products or products with a high solvent
concentration cannot be dried without special protective measures
and devices such as e.g. a cooling trap for protection of the
vacuum pump (if necessary check with our service department).
Besides, the unit may be damaged by corrosion.
Special caution is necessary when using azides because a
dangerous explosive develops in combination with copper or non-
ferrous metals! It is absolutely essential to consult our service
department!
1.6.3. ADVICE! Cleaning and Maintenance of the Unit!
For infectious, toxic, pathogenic and radioactive
substances the corresponding safety regulations must be
observed.
1.6.4. WARNING! Freezing of Limbs to Surfaces!
During operation of the freeze-dryer dangerous
situations in the ice condenser chamber may arise. When putting
in the shelves take care that limbs do not come into contact with
the condenser in the ice condenser chamber as the limbs may
become frozen to the surface. The limb can only be detached from
the surface by applying heat. Liquid should not be used.
1.6.5. ADVICE! Transport Instructions!
Please keep the packaging for possible subsequent dispatch.
The freeze-dryer should be carried by two persons by holding it
underneath on both sides.
WARNING! When transporting or putting down the unit do not hold
the plastic control panel. Please note: When putting the unit down
on a surface there is a danger of squeezing hands or fingers.
WRONG CORRECT