Scope of delivery, Standards and regulations, Safety instructions – Martin Christ Beta 2-8 LDplus User Manual
Page 13: Caution! disconnect mains plug
Operating Manual Freeze Dryer BETA 1-8 LDplus / BETA 2-8 LDplus
General Information 13
1.3.1. NOTE! Technical documentation!
The technical documentation of the freeze-dryer
BETA 1-8 LDplus /BETA 2-8 LDplus (e.g. circuit diagram, cooling
system) and the safety data sheets of the manufacturers of
regrigerant and heat transfer medium is not attached to this
operating manual.
Please ask for the documents in case of need via Internet at
www.martinchrist.de
by using the form "service request".
1.4. Scope of delivery
The scope of delivery includes:
1 tube of high-vacuum grease
1 litre vacuum pump oil (only in case a pump is
delivered)
0.5 m drain hose (silicone 9 x 12 mm)
1 operating manual and further detailed technical
documentation
The scope of delivery does not include:
Commissioning of the unit (inside Germany) can be
performed upon request and will be invoiced at cost.
Installation of the exhaust pipe of the vacuum pump
(not necessary when using an exhaust filter).
1.5. Standards and Regulations
Please refer to the enclosed EU Declaration of Conformity.
1.6. Safety Instructions
1.6.1. CAUTION! Disconnect Mains Plug!
As current-carrying parts are accessible inside the unit
the mains plug must be disconnected before the side panels are
opened or before the control panel is removed.
For maintenance work the unit must be switched off with the mains
switch.