Luxul XBR-4400 - Manual (Page 32)

32
XBR-4400
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XBR-4400 Vers: 07314
3.6.1 PPTP Server
This page displays the PPTP Server Settings currently configured on the Router.
Select the menu VPN>>PPTP Server to display the following page.
„
PPTP Server: Displays the current PPTP VPN settings of the Router.
w
PPTP Server: Allows you to Enable or Disable the PPTP Server on the Router.
Disabled is the default setting.
w
Starting IP Address: Allows you to set the Starting IP Address of the DHCP Pool
used by the VPN Server. 192.168.0.20 is the default setting.
w
Ending IP Address: Allows you to set the Ending IP Address of the DHCP Pool used
by the VPN Server. 192.168.0.30 is the default setting.
w
Save: This button is used to Save the configuration changes made on this page.
Once you have clicked Save you may move to other pages in the Router setup.
Most changes will require a Reboot to allow the changes to take effect.
w
Reboot: This button is used to Reboot the Router after making configuration
changes or can be used to Reboot the Router for any reason.
w
Cancel: This button Cancels any changes made on this page.
NOTE: After making any changes to the VPN Server you must click the Save
button to Save your changes, then you must click the Reboot button
for the changes to take effect. You can click the Save button and
proceed to other pages without losing your configured changes.
NOTE: The DHCP Pool used by the VPN Server must be outside the DHCP
Pool used by the DHCP Server (see Network>>DHCP Server for
current settings)..