User guide – Luxul XBR-4400 User Manual

Page 23

User Guide

Other trademarks and registered trademarks are the property of their respective owners

VLAN Configuration: Allows you to configure your newly added VLAN. Including

the VLANs DHCP Server settings.

VLAN ID: Displays the VLAN ID of the VLAN being configured.

Description: Allows you to add a Description for easy identification.

Inter VLAN Routing: Allows you to Enable or Disable Routing between VLANs.
When enabled devices on any VLAN with Inter VLAN Routing Enabled will be able
to see each other, if you are using the VLAN to isolate devices do not enable Inter
VLAN Routing. Enabled is the default setting.

Ports: Displays the current LAN Ports of the Router.

Enable: Allows you to add the desired Ports to the VLAN by simply checking the
checkbox.

Egress Rule: Allows you to specify the Egress Rule of the port. Tagged is the
default setting. This is the recommended setting in most instances, please consult
your Network Administrator to verify the needs of each VLAN.

IP Address: Allows you to configure the LAN IP Address of the Router in this VLAN.
This will also define the Subnet of the VLAN and must be different than the IP
Address of the default LAN on the Router (i.e. if your default LAN is 192.168.0.1 and
Subnet Mask is 255.255.255.0, the default settings of 192.168.1.1 and Subnet Mask of
255.255.255.0 will work for the new VLAN).

Subnet Mask: Allows you to specify the LAN Subnet Mask of the Router in this
VLAN. 255.255.255.0 is the default setting.

DHCP Range: Displays the current DHCP Pool settings of the Router in this VLAN,
these settings can be viewed or modified here.

Start: Allows you to set the Starting IP Address of the DHCP Pool in this VLAN.
192.168.1.100 is the default setting for the first VLAN added.

End: Allows you to set the Ending IP Address of the DHCP Pool in this VLAN.
192.168.1.200 is the default setting for the first VLAN added.

Lease Time (hours): Allows you to set the number of Hours the DHCP Lease issued
to the Client Device is valid before requiring a DHCP Renew in this VLAN. 12 Hours
is the default setting.

Save: This button is used to Save the configuration changes made on this page.
Once you have clicked Save you may move to other pages in the Router setup.
Most changes will require a Reboot to allow the changes to take effect.

Reboot: This button is used to Reboot the Router after making configuration
changes or can be used to Reboot the Router for any reason.

Cancel: This button Cancels any changes made on this page.