Luxul XBR-4400 - Manual (Page 31)

31
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
w
Protocol: Allows you to specify what Protocol is targeted by this Rule TCP, UDP or
All. All is the default setting.
w
Ports: Allows you to specify the Port(s) targeted by this Rule. All is the default set-
ting. You can specify multiple Ports in a single rule by separating the Port numbers
with a comma (i.e. 23,53,80,443).
w
Add: Click the Add button to add your QoS Rule to the QoS Table. This also
Saves the QoS Rule, allowing you to browse to another page in the Router before
rebooting to apply the changes.
„
QoS Rules Table: Displays the QoS Rules currently running on the Router.
w
Service Level: Displays the QoS Service Level used for this Rule. Normal is the
default setting.
w
Source Host: Displays the IP Address(es) this Rule will apply to. All is the default
setting. All will apply this Rule to all packets transmitted to the WAN Port of the
Router.
w
Protocol: Displays what Protocol is targeted by this Rule TCP, UDP or All. All is the
default setting.
w
Ports: Displays the Port(s) targeted by this Rule. All is the default setting. You can
specify multiple Ports in a single rule by separating the Port numbers with a comma
(i.e. 23,53,80,443).
w
Del: This button allows you to Delete the selected QoS Rule and Saves the changes
allowing you to browse to any other setup page. Most changes will require a
Reboot to allow the changes to take effect.
NOTE: After making any changes to QoS you must click the Save/Add
buttons to Save your changes, then you must click the Reboot button
for the changes to take effect. You can click the Save/Add buttons
and proceed to other pages without losing your configured changes.
NOTE: If QoS is configured incorrectly it may be required to Reset the
Router to Default Settings. Please back up any configuration before
attempting to Enabling QoS.
3.6 VPN
There are four submenus in the VPN menu: PPTP Server, PPTP Users, L2TP and IPSec.
Click a submenu to view and/or modify the corresponding settings.