Labconco Biological Safety Cabinets 34269 Series - Manual (Page 4)

Original instructions
T T
A A B B L L E E
O O
F F
C C
O O N N T T E E N N T T S S
CHAPTER 1: INTRODUCTION
1
CHAPTER 2: PREREQUISITES
2
Space Requirements 2
Clearance 2
Location Requirements 3
Exhaust Requirements 4
Electrical Requirements 4-5
Service Line Requirements 5
User-Supplied Microscope Requirements –
With Scope-Ready TM Package Only 6
User-Supplied Microscope Requirements –
With Temp Zone TM Package Only 6
CHAPTER
3: GETTING STARTED 7
Unpacking the Biosafety Cabinet 8
Preparing the Biosafety Cabinet for Operation 8
Moving and Lifting the Biosafety Cabinet 9
Installing the Biosafety Cabinet on an Existing Work Surface 9
Installing the Biosafety Cabinet on a Labconco Base Stand 9
Telescoping Base Stands 10
Manual or Electric Hydraulic Lift Base Stands 10
SoLo Electric Hydraulic Lift Base Stands 10
Connecting the Biosafety Cabinet to Utility Service Lines 11
Optional Ventus TM Exhaust System Connections 12
Optional Vacu-Pass TM Cord and Cable Portal Use 13
Drain Valve Installation 14
Microscope Installation (optional) 15-16
Circulator Installation (optional) 17-18
Initial Certification 19