Lab.gruppen LM 44 - Manual (Page 42)

36
Front Panel Interface
Lake LM Series Operation Manual Rev 1.2.8
Frame Label
The Frame Label as defined in the Lake Controller is displayed in this menu. It is also displayed at the
top-left of the screen in Meter Mode, Home View.
Serial Number (Serial No.)
The printed serial number on the back panel of the device is also electronically embedded in the hardware,
and therefore cannot be removed or altered if stolen.
Network
Pressing the NETWORK button displays a further screen containing network configuration information.
All parameters are view-only on the front panel and are either not editable, or can only be adjusted via the
Lake Controller.
A summary at the top right of the screen confirms whether a valid connection is present for both Ethernet
ports, and whether the Lake Controller is online.
▸ IP Addr: Displays the Internet Protocol address for the selected unit and can only be changed via the
Lake Controller software. Please refer to the Lake Controller Operation Manual for further details.
▸ IP Mask: Displays the IP address subnet mask for the selected unit and can only be changed via the
Lake Controller software. Please refer to the Lake Controller Operation Manual for further details.
▸ MAC: Displays the unique Media Access Control Ethernet address for the processor. This value cannot
be changed.
▸ F.ID: Displays the Frame ID, a unique Lake product identifier that cannot be changed.
6.10.4.2 Frame Reset and Configuration
MENU > FRAME > FRAME RST
Use this option to display a further menu with options to reset all parameters back to their original factory
default values, or to reconfigure the Frame in a different mode (i.e. Contour or Mesa). See section 8.3 for a
full list of the default factory reset parameter values.
Three types of reset are provided: Factory Reset, Contour Reset and Mesa Reset.
Factory Reset
A Factory Reset will reset all settings and parameters to the original factory-defined default values. This
includes the deletion of any Frame Presets stored within the device, and the relevant Frame configuration
for the device (LM 26 = Contour; LM 44 = Mesa). It also resets the IP Address and all network related
settings; a hard power cycle is required to complete this reset.