Konig Electronic IP baby monitor - Manual (Page 8)

ENGLISH
8
7. Your iOS device should have disconnected from “Wi-Fi-cam-p2p” and reconnected to your
home router. Please check that your iOS device has connected to your home router now, via
“Settings” -> “Wi-Fi”. If it has not, please connect your smartphone to your home router Wi-Fi.
8. Open the “uCare Cam” smartphone App, and you can click on the camera name in the
Camera List view to connect.
E. Android – Setup IP baby monitor Wi-Fi
There are two methods to set up IP baby monitor to connect to a new Wi-Fi Router.
Method 1: Use WPS (Wi-Fi Protected Setup)
Available if your Wi-Fi router supports WPS and it is set to use WPA or WPA2 security
encryption. WEP security encryption is not supported for WPS mode. An easy way to check if
your router supports WPS is to look for a button that says “WPS” on the router. It may also be
called “AOSS” or “QSS”.
1. Press and hold the WPS/RESET button for 10 seconds at the back of the camera. It will reset and
restart the uCare Cam. After about 60 seconds, the LED colour should flash Green and Red.
2. Press “WPS” button on Wi-Fi router.
3. Press the WPS/RESET button on the back of the IP baby monitor for 2 seconds.
If IP baby monitor has entered the WPS connection mode, the status LED colour will turn a
fast blinking Green.
4. IP baby monitor will try for up to 2 minutes to connect to the Wi-Fi Router using WPS.
5. If the LED colour changes to Orange, your IP baby monitor has successfully connected to
your router. If the LED does not change to orange, the setup has failed. Please make sure
the IP baby monitor is within Wi-Fi distance of your Router, press the WPS/RESET button
for 10 seconds to reset uCare Cam, and try the setup again.
6. Use the smartphone App to add IP baby monitor into Camera list. See instruction manual –
“Android - Add IP baby monitor (already connected to router) to App”.
Method 2: Use Router Mode
Please have your Wi-Fi password readily available as you will need it in this process.