Konig Electronic IP baby monitor - Manual (Page 10)

ENGLISH
10
F. iOS – Add IP baby monitor (already connected to Router) to App
There are three ways to add a IP baby monitor to the Camera List view if the IP baby monitor is
already connected to the internet. You can:
• Scan for IP baby monitor in local intranet
• Scan QR code at the back of IP baby monitor
• Type in 20 digit code
Method 1: Scan for IP baby monitor in local intranet
1. Make sure your smartphone is connected to the same
router as your uCare Cam. Open up the Smartphone
App “uCare Cam” and click on the “+” at the top
right of the screen.
2. Click on “Scan Camera’s UID in intranet”.
3. You will see a list of UIDs that were found on your
local intranet.
4. Click on the UID you would like to add.
5. Please enter a Camera name (2 to 20 characters) and
the camera password. Default password is 0000. Click
“Done” on the top right of window.
6. You will see the Camera name now in Camera List view. It should indicate that the Camera
is “Online”. To connect to the Camera, please click on the Camera name. If the Camera is
not “Online”, you may need to force reconnect. To force reconnect, click on the right arrow
and click on “Reconnect”. Click on the Camera name once it shows “Online”.
Method 2: Scan QR Code at back of the uCare Cam
1. Make sure your smartphone is connected to the internet. Open up the Smartphone App
“uCare Cam” and click on the “+” at the top right of the screen.
2. Click on “Scan camera QR code”.
3. You will see your smartphone camera live view. Face your smartphone camera towards the
QR code found on the back of the uCare Cam. Please make sure the QR code is clear and
fully viewable in the screen. Once the QR code has been detected, the App will display the
UID in the App window.
4. Please enter a Camera name (2 to 20 characters) and the camera password. The default
password is 0000. Click “Done” on the upper right of the screen.