IOTA ICE-420-EM-A User Manual

Ice-420-em-a, Important safeguards, Instruction manual

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

CAUTION – To prevent electrical shock, do not mate unit connector until installation is complete and A.C.

power is supplied to the unit.

CAUTION – This fixture provides more than one power supply output source. To reduce the risk of electrical

shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by discon-

necting the unit connector.

CAUTION – This is a sealed unit. The integral, high temperature Ni-Cad battery is not replaceable. Replace

the entire unit when necessary and recycle or dispose of the nickel-cadmium battery properly.

4. The

ICE-420-EM-A is for use with grounded, UL Listed, damp location rated fixtures. Not for use in heated air

outlets or hazardous locations.

5. The

ICE-420-EM-A requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the

unused A.C. lead.

6. Do not mount near gas or electric heaters.

7. The

ICE-420-EM-A should be mounted in locations and at heights where it will not readily be subjected to

tampering by unauthorized personnel.

8. The

ICE-420-EM-A will cold strike and operate one 10W through 70W, or two 10W through 32W, 4 pin Rapid

Start compact fluorescent lamps. Contact Customer Service for additional lamp usage.

9. The

ICE-420-EM-A is compatible with most electronic A.C. ballasts (including multiple lamps) as follows:

Electronic ballasts – one or two lamp emergency operation.

10. Suitable for use in damp locations.

11. For use in -18

C minimum, 50

° C maximum ambient temperatures.

12. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition, void

warranty, and result in non-compliance with UL specifications.

13. Do not use this equipment for other than intended use.

14. Install in accordance with the National Electrical Code and local regulations.

15. Installation and servicing should be performed by qualified personnel.

16. Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility

before final installation.

SAVE THESE INSTRUCTIONS

INSTRUCTION MANUAL

ICE-420-EM-A

TBTS

COLD-WEATHER SERIES D

10W–70W RAPID START

4 PIN COMPACT LAMP

EMERgENCy LIghTINg EqUIPMENT

P.O. BOX 11846 TUCSON, AZ 85734

(520) 294-3292 • FAX (520) 741-2837