IOTA I-42-L User Manual

I-42-l, Important safeguards, Instruction manual

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

CAUTION – Connect the battery to the unit before applying A.C. power.

CAUTION – To prevent electrical shock, do not mate unit connector until installation is complete and A.C.

power is supplied to the unit.

CAUTION – This fixture provides more than one power supply output source. To reduce the risk of electrical

shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by discon-

necting the unit connector. In addition, the circuit board should be mounted so that no live parts are accessible

during routine maintenance or relamping.

CAUTION – This is a sealed unit. The integral, high temperature Ni-Cad battery is not replaceable. Replace

the entire unit when necessary and recycle or dispose of the nickel-cadmium battery properly.

5. The

I-42-L is for use with grounded, UL Listed, indoor fixtures. The acceptability of the combination must be

determined by Underwriters Laboratories. Refer to the Engineering Considerations section for proper installation.

6. T

I-42-L and A.C. ballast must be on the same branch circuit.

7. The

I-42-L requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the unused A.C.

lead.

8. Do not mount near gas or electric heaters.

9. The

I-42-L should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

10. The

I-42-L will cold strike and operate one 10W through 42W, or two 10W through 18W, 4-pin Rapid Start

compact fluorescent lamps. Contact Customer Service for additional lamp usage.

11. The

I-42-L is for use with unusually shaped fluorescent fixtures such as wall packs, sconces, and recessed

stair fixtures.

12. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition, void

warranty, and result in non-compliance with UL specifications.

13. Do not use this equipment for other than intended use.

14. Install in accordance with the National Electrical Code and local regulations.

15. Installation and servicing should be performed by qualified personnel.

16. Lighting fixture manufacturers, electricians and end users need to ensure product system compatibility before

final installation.

SAVE THESE INSTRUCTIONS

I-42-L

INSTRUCTION MANUAL

TBTS SERIES AC

10W–42W RAPID START

4 PIN COMPACT LAMP

EMERgENCy LIghTINg EqUIPMENT

P.O. BOX 11846 TUCSON, AZ 85734

(520) 294-3292 • FAX (520) 741-2837