IOTA I-26-EM-A User Manual

I-26-em-a, Important safeguards, Instruction manual

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

CAUTION – To prevent electrical shock, do not mate unit connector until installation is complete and A.C.

power is supplied to the unit.

CAUTION – This fixture provides more than one power supply output source. To reduce the risk of electrical

shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by discon-

necting the unit connector.

CAUTION – This is a sealed unit. The integral, high temperature Ni-Cad battery is not replaceable. Replace

the entire unit when necessary and recycle or dispose of the nickel-cadmium battery properly.

DO NOT USE OUTDOORS. The I-26-EM-A is for use with grounded, UL Listed, damp location rated, indoor

fixtures. Not for use in heated air outlets or hazardous locations.

5. The

I-26-EM-A requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the unused

A.C. lead.

6. The

I-26-EM-A and A.C. ballast must be on the same branch circuit.

7. Do not mount near gas or electric heaters.

8. The

I-26-EM-A should be mounted in locations and at heights where it will not readily be subjected to tamper-

ing by unauthorized personnel.

9. The

I-26-EM-A will cold strike and operate one 18W/26W, quad tube, compact fluorescent lamp, two-pin base,

including integral starter, each with a single lampholder per lamp.

10. The

I-26-EM-A can be used with one or two lamp fixtures; however, only one lamp can be operated in emer-

gency mode.

11. Suitable for use in damp locations.
12. For use in 0° C minimum, 50° C maximum ambient temperatures.
13. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition, void

warranty, and result in non-compliance with UL specifications.

14. Do not use this equipment for other than intended use.

15. Install in accordance with the National Electrical Code and local regulations.

16. Installation and servicing should be performed by qualified personnel.

17. Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility before

final installation.

SAVE THESE INSTRUCTIONS

I-26-EM-A

INSTRUCTION MANUAL

SERIES D

QUAD TUBE

EmERgENCy

LIghTINg EQUIPmENT

P.O. BOX 11846 TUCSON, AZ 85734

(520) 294-3292 • FAX (520) 741-2837