Hatteland Display 26 inch - HD 26T21 STD (Widescreen) - Manual (Page 54)

54 User Controls
IND100064-42
|--------3--------
OSD Misc - Presets - Save *Available in “Full Mode” only
Allows to save current state of all function and values to user defined presets. The contents
of the submenu is listed below.
Settings as follows:
“User 1” = Save all OSD settings to User 1 slot.
|--------3--------
OSD Misc - Presets - Load
Allows to save current state of all function and values to user defined presets. The contents
of the submenu is listed below.
Settings as follows:
“User 1” = Load all OSD settings from User 1 slot.
|---2---
OSD Misc - OSD Mode *Available in “Full Mode” only
Configuring the OSD Mode to show as simplified/most common functions or advanced (full) setup.
The change you do here will be stored in memory and stays as such even after powering off the
unit.
Settings as follows:
“Simplified” = A few functions is not visible/available in this state. For most uses this
is the preferred setting and are safe for the display functionality and
continuous trusted operation on the unit.
“Full” = All functions and parameters is visible/available in this state. Some of the
settings adjusted could impact on display functionality and image quality.
Only experienced and qualified personnel should access and change
parameters when in this mode. Also, more technical details about signals,
frequency will be available. The layout of the OSD menu will also change
to a slightly bigger window with more menus and functions available.
3 6 2
Full Menu
● Note: When requesting a “Full” mode from a Simplified mode, the user are required to enter a key code.
This code is factory preset to “362”. You can enter the code by using navigation, (-) Brilliance (+) and “MENU”
to confirm. After a successful entering of the key code, the OSD menu will always be in this state (even after
power off). To revert back to “Simplified” mode, simply change it back and exit the OSD menu.
OSD Menu Functions