Hatteland Display 26 inch - HD 26T21 STD (Widescreen) - Manual (Page 48)

48 User Controls
IND100064-42
OSD Menu Functions
OSD Menu Functions
The following section covers all possible settings that the user can (in a certain mode) encounter or needs
to adjust via easy understandable menus, text and navigation. For simpler reading the menu choice “Exit”
has been left out of description in this chapter intentionally. Whenever “Exit” is available, you can exit
current menu and go back to the previous one visited. When there is no more previous menus available,
the OSD menu overlay will be shut off and hidden. All settings are saved real-time or when you exit a menu
(including timeout of menu visibility).
The number shown in the “|------x------” line gives the indication of the submenu level where the function is
located (also reference to the table in the previous chapter). It requires the user to touch the “MENU”
symbol to enter that submenu.
Please note: Available functions described may deviate slightly from actual OSD menu on your unit.
This is due to different OSD software configurations and customized solutions. Shown here are factory standards.
Source
Lets you configure signal source input (DVI or VGA) as well as activate or disable the Auto Source
functionality. The contents of these submenus are listed below.
|---2---
Source - VGA
Sets the signal source detection to “VGA” (Analog RGB/VGA).
|---2---
Source - DVI
Sets the signal source detection to “DVI” (Digital).
|---2---
Source - Auto Source
Set to either ‘Yes’ or ‘No’. Signal is automatically searched for and selected. If any signal is
disconnected physically, the video controller will automatically search and select from the
next item available in the list, such as; “DVI” (Digital) or “VGA” (Analog RGB/VGA).
● Note: If all signals was physically disconnected from the unit, the Auto Source function will loop endlessly until it detects
a valid signal to display.