Hatteland Display 26 inch - HD 26T21 STD (Widescreen) - Manual (Page 38)

38
IND100133-49
Connection area of unit (illustration)
Physical Connections
Reduce Cable Tension
To reduce tension of the cables you connect, secure them with
a cable tie to the available chassis hinges located near the
connectors.
Note: Amount of chassis hinges can vary depending on model.
Grounding Screw Power Input DC
USB Touch
VGA/RGB In RS-422/RS-485 COM
RS-232 COM DVI-D In
USB TOUCH:
Connect a TYPE B USB Cable between this connector and your PC. Suitable drivers to install and calibrate the
touchscreen are available on the separate installation media delivered with the unit. Port is USB2.0 (<5m).
RS-422 / RS-485 COM I/O:
The COM (non-isolated RS-422/485) allows functionality to communicate with serial based equipment including
external buzzer functionality. Connect and fasten your cables from your compatible external equipment to the 5-pin
Terminal Block 3.81 connector. Please review the “Pinout Assignments” chapter as well as “Housing / Terminal Block
Connector Overview” in this manual for more information
DVI-D IN:
Connect your DVI cable to the DVI-D 18+1P, Single Link Connector (female). Secure your DVI cable to the hex
spacers provided on the unit and make sure you do not bend any of the pins inside the connector. Connect the other
end of the cable to the DVI connector on your equipment and secure it.
Note: 19 inch unit used as example above, please review specifications for your actual model.
VGA/RGB Out
Power Input AC