Hall Research HR-4P - Manual (Page 18)

Model HR-4P
16
3.19 Menu System
The HR-4P Programmer consists of three menus which allow you to easily perform more
specific tasks.
3.20 File
The File menu consists of the following menu items as shown in Figure 17.
• New – Erase all the user configuration strings and IR codes and
start with a blank configuration.
• Open – Open a previously saved configuration file.
• Save – Saves a configuration file with the user specified filename.
• Exit – Exit the HR-4P Programmer Software.
• Exit – Exit the HR-4P Programmer.
Figure 17 – File Menu
3.21 Tools
The Tools menu consists of the following menu items as shown in Figure 18.
Note that certain items are disabled (grayed out) if the GUI is NOT in communication with the HR-4P unit.
• Reset Unit – Reset your HR-4P unit after a new I/O
configuration or IR configuration.
• Factory Defaults – Clears all information stored in HR-
4P unit and resets it to the factory shipped configuration.
• Refresh – Refreshes the tab page.
• Short Command Format – Set unit to short command
format.
• Long Command Format – Set unit to long command
format.
Figure 18 – File Menu
3.22 Help
The Help menu consists of the following menu items as shown in Figure 19.
• Contents – Display the help file contents. A previously installed
PDF reader is required in order to view the document.
• About… – Display the Version and Support information for the
GUI software.
Figure 19 – Help Menu