Hall Research HR-4P - Manual (Page 13)

Programmable Serial Controller
11
3.12 IR Codes
• IR code’s can be part of the configuration string. Supported IR formats are
available for sending known IR Addresses and Commands. Ensure that the IR
Protocol, Address and Commands have been tested to ensure proper
response from the controlled devices. A compatible IR Emitter is required to
send IR Codes.
• Select the desired Condition and change Action to IR. When done, the user
clicks the Add button to append the command to the existing user string as
shown in Figure 8.
Figure 8 – IR Codes
• Up to 32 IR Codes that have been ‘learned’ can be transmitted from the unit. A
compatible IR detector is required to LEARN IR Codes. A compatible IR
Emitter is required to send IR Codes.
• Select the desired Condition, change Action to IR, change IR Protocol to
Memory Recall and select the desired location that the IR code was saved
into.
• When done, the user clicks the Add button to append the command to the
existing user string as shown in Figure 9.
Figure 9 – IR Memory Recall