Hall Research HR-4P - Manual (Page 16)

Model HR-4P
14
• The Upload button is used to store this information in the HR-4P unit.
Figure 13 – I/O Control
3.17 IR
• The IR tab is used to configure the IR capabilities of the HR-4P unit. A
compatible IR Detector and Emitter are required to fully utilize the IR features.
• When the IR is configured as an Input, the HR-4P unit can learn any supported
IR codes from the user’s remote control. These IR codes can be stored into 1
of 32 IR Memory locations in the unit.
• IR codes stored in memory can an 8 character name associated with it, making
it easier to be identified later.
o Check the IR Enabled box
o To LEARN IR Codes
ƒ Select the Input radio button and click Upload
ƒ Install IR Detector on HR-4P Unit
ƒ Click the LEARN button
ƒ Press IR Remote Control button while pointing at IR Detector
ƒ Store code learned into IR Memory Location with name if desired
o To SEND IR Codes
ƒ Select the Output radio button and click Upload
ƒ Install IR Emitter
ƒ Recall IR memory location
ƒ Click the SEND button to play the remote code from the HR-4P unit