Glow-worm Clearly Hybrid - Compact System - Manual (Page 25)

0020096883_01 - 06/10 - Glow-worm
- 23 -
INSTALLATION
12.7.5 Resetting parameters
This feature allows you to reset the parameters of the control
unit (factory setting).
b
The resetting of factory settings is irreversible.
Any customised confi guration of the control unit
will be lost.
• Using the buttons ,
select Settings reset on the screen.
• Press the button to confi rm.
• Increase or decrease with the
buttons to display the
desired value.
• Press the button to confi rm.
• Press the button .
12.8 Commissioning
This menu allows you to carry out the necessary operations on
the appliances following installation.
• Using the buttons , select
Commissioning on the screen.
• Press the button to confi rm.
12.8.1 Filling the heating circuit
i The Systempro control unit is used to open the
valves of each zone during fi lling, if more than one
heating zone is installed.
• Select Fill htg circuit on the screen
using the buttons .
• Press the button to confi rm.
The screen shows the pressure
measured in the system.
• Activate fi lling mode by pressing the
button .
• Refer to the boiler instructions for
fi lling the boiler.
The screen displays the pressure
measured in the system and that
installation fi lling is in progress.
• To stop fi lling press the button .
• Close the fi lling loop.
• Press the button to confi rm.
12.8.2 Venting the heating circuit
Venting of the heating circuit enables the purging of any air in
the heating circuit.
• Using the buttons ,
select Air venting on the screen.
• Press the button to confi rm.
• Open the different heating circuit air vent.
• Using the buttons ,
select Vent heating circuit on the
screen.
• Press the button to confi rm.
• Confi rm with the button in
order to begin the venting process.
The venting process is carried out for
15 minutes. You can simultaneously run
the venting of the HP circuit.
• Press the button .
b
When venting is complete, close the different
heating circuit air vent.