Glow-worm Clearly Hybrid - Compact System - Manual (Page 21)

0020096883_01 - 06/10 - Glow-worm
- 19 -
INSTALLATION
• Using the buttons ,
select Connection on the screen.
• Press the button to confi rm.
• Press the button on the outdoor
sensor to connect.
ON
1
Key
1
Outdoor sensor button
i Once the sensor is detected, the message
«Connection completed» is displayed.
If unsuccessful, the message "Connection failure" is
displayed.
Press the button
and repeat the operation.
• Press the button .
i The External T°C Correction allows you to correct
the temperature measured by the outdoor sensor
(+/- 5 ° C, at intervals of 1 ° C - factory setting: 0).
• Using the buttons ,
select External T ºC correction on
the screen.
• Press the button to confi rm.
This setting is automatically modifi ed in
the installer room thermostat menu.
• Increase or decrease with the
buttons to display the
desired correction.
• Press the button to confi rm.
• Press the button twice.
12.6 Self check
e
Do not modify the cables when connected to the
mains.
The automatic test allows you to check:
- EBUS inputs,
- NTC inputs,
- the RF connection with the room thermostat,
- the outdoor sensor radio connection.
The other connections are not tested and should be
visually inspected during installation or confi guration
modifi cations.
• Using the buttons ,
select Self check on the screen.
• Press the button to confi rm.
• Check that all installation’s
components are switched on.
• Confi rm the start of the test with the
button .