FeiYu Tech FY-41AP Lite - Manual (Page 18)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 16
NO. Setup instructions NO. Setup instructions
1 Auto-control rudder surface reverse 10 Circling radius setting
2 Control gain 11 Farthest flight distance setting
3 Ailerons 12 Airspeed adjust setting
4 Elevator 13 Rudder mixing mode
5 Throttle 14 Initialize gyroscope
6 Rudder 15 Initialize airspeed sensor
7 Three-switch mode selection 16 Save the settings
8 FY-41AP Lite install setting 17 Exit the Settings interface
9 Cruising speed setting
Method two:
Setting FY-41AP Lite via “FYGCS 5.11 for 41&DOS” software
1 ) Please visit the official website: www.feiyu-tech.com . Download the newest setting
software ―FYGCS 5.11 for 41&DOS‖ and the USB driver at the download page which
related to FY
–41AP Lite products.
2 ) After successfully install the USB driver, insert the USB-TTL interface cable into
computer USB COM port(don‘t connect TTL port to any other device ) , the system will
correctly identify the USB -TTL data cable, then you will find there is more than one
port(COM and LPT), the port COM6 in the ―Silicon Labs CP210x USB to UART Bridge
(CO M6)‖ is the Virtual serial number.
Inserter a few times for confirmation the virtual serial number. After that, you can use
the new USB data cable normally.
3 ) Install Google Earth plug-in 6.1 version or above.
Two methods to install the plug-in .
Method one : Networking installed directly.
Method two : Install the local plug-in provided by us, you can download at our official
website: www.feiyu-tech.com .
Method for checking whether the Google Earth plug-in have been installed
successfully. Enter the following url :
http://www.google.com/earth/explore/products/plugin.html . If the plug-in have been
installed successfully, you can see the following 3D map directly.