EXFO QA-805 - Manual (Page 34)

W2CM-10Gb Ethernet Interface Series
26 QA-805 and W2CM Interface Module
Module Installation
W
2
CM-10GbE Lite/W
2
CM-4GbE 1-slot module
Module Installation
The W
2
CM modules are hot-swappable, but care must be taken when and
how the modules are removed.
Inserting a Module
Follow these steps to insert a module into the QA-805 Chassis:
1. Remove any Filler Cards/Air Baffles required, to provide space for the
module being inserted.
2. Before inserting the card, ensure that the levers on either side of the
card are in the fully open position, perpendicular to the faceplate.
3. Align the card with the card rails and gently glide the card straight into
the chassis. Ensure that the guide-pins insert into their associated holes
in the chassis.
4. Ensure that no cables are between the card's faceplate and the chassis.
5. To fully seat the card into the chassis, use constant pressure while
closing both levers, allowing the levers to pull the card into position.