ENMET EX-6165 - Manual (Page 4)

ENMET Corporation EX-6120, 6165 S ERIES IR
1
1.0 Introduction
The ENMET EX-6120, 6165 S ERIE s IR Fixed Gas Detectors for the detection of Flammable gases is ATEX Flameproof
Certified for use in Group IIC hazardous locations. Directive 94/9/EC ATEX and the equivalent rating of Class1,
Division 1, Groups A, B, C and D
Harmonised Standards Used:
EN60079-0:2006 Electrical apparatus for explosive gas atmospheres – Part 0: General requirements.
EN60079-1:2007 Explosive atmospheres – Part 1: Equipment protection by flameproof enclosures “d”.
Notified Body for Hazardous Area Certification:
SIRA Certification Service
Rake Lane, Eccleston,
Chester, CH4 9JN.
Notified Body Number : 0518
Notified Body for ATEX Quality Assurance Notification:
Baseefa
Rockhead Business Park
Staden Lane, Buxton SK17 9RZ, UK
Notified Body Number : 1180
Hazardous Area Certificate Number:
SIRA 08ATEX1031X
II 2 G Ex d IIC
T4 (Ta = -20
O C + 60 O C )
ATEX Quality Assurance Notification Number:
2056
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the EX-6120, 6165 S ERIES IR and examine it for shipping damage. If such damage is observed, notify both
ENMET customer service personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will not
honor any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the
carrier in good condition.
When it was picked up by the carrier at ENMET , it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local
office and request immediate inspection of the carton and the contents.
•
After the inspection and after you have received written acknowledgment of the damage from the carrier,
contact
ENMET Customer Service for return authorization and further instructions. Have your Purchase
Order and Sales Order numbers available.
ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability
coverage, usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage. ENMET only insures shipments with the shipping
company when asked to do so in writing by our customer. If you need your shipments insured, please forward a
written request to
ENMET Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify ENMET Customer Service within 5 days of
receipt at the following address:
ENMET Corporation
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the EX-6120, 6165 S ERIES IR is received
as ordered. [Each EX-6120, 6165 S ERIES IR is labeled with its target gas.] If there are accessories on the order,
ascertain that they are present. Check the contents of calibration kits. Notify ENMET customer service personnel of
any discrepancy immediately.
1.3 Serial Numbers
Each EX-6120, 6165 S ERIES IR is serialized. These numbers are on tags on the equipment and are on record in an
ENMET database.