ENMET EX-6165 - Manual (Page 17)

EX-6120, 6165 SERIES IR ENMET Corporation
14
9 Certification
The EX-6120, 6165 S ERIES IR (FGD10 Series) of Gas Detectors are ATEX and IECEx certified for use in potentially
explosive atmospheres and is marked as follows:-
** Denotes additional characters that define the gas detector configuration e.g. Enclosure type and sensor arrangement.
YYYY – Denotes year of manufacture.
Special Conditions of Safe Use
Only Loctite 243 or a compound of equal strength shall be reapplied to the threads of the sensor after replacing the
sensing element
Electrical data
Power supply - 8Vdc to 24Vdc, 5W
Relay contact rating – 300Vac, 3 Amps
Installation instructions
The cable entry devices and blanking elements of unused apertures shall be of a certified flameproof type, suitable for
the conditions of use and correctly installed.
With the use of conduit, a suitable certified sealing device such as a sealing fitting with compound shall be provided
immediately at the entrance to the flameproof enclosure.
10 EX-6120, 6165 S
ERIES
IR Accessories and Calibration Gas
EX-6120, 6165 S ERIES IR partial list of typical accessories and calibration gas ENMET part number
Description of Accessory Part Number
Sensor Contact ENMET Corp
Calibration Adaptor (for sensors without weather guard) 03700-058
Regulator Assembly 02506-004
Calibration Gas, 50%LEL Methane (for 0 – 100% LEL CH4) 03220-050
Calibration Gas, 2000ppm CO2 (for 0 – 500ppm CO2) 03220-2000
Weather Guard 04546-012
Maintenance Tool, Sensor 73413-210
WARNING – DO NOT OPEN WHEN AN EXPLOSIVE GAS
ATMOSPHERE IS PRESENT
GAS DETECTOR TYPE FGD10 **
STATUS SCIENTIFIC IECEx SIR 08.0009X
CONTROLS LTD. T4 (Ta -20 O C to +60 O C)
MANSFIELD
NG18 5ER.UK.
II 2 G Ex d IIC 1180
SIRA 08ATEX1031X
SERIAL No. XXXXXX CIRCUIT RATING: 24VDC, 5W
YYYY RELAY CONTACT RATING:
300VAC. 3A MAX.