ENMET EX-6165 - Manual (Page 25)

EX-6120, 6165 SERIES IR ENMET Corporation
22
WARRANTY
ENMET warrants new instruments to be free from defects in workmanship and material under normal use for a period
of one year from date of shipment from ENMET . The warranty covers both parts and labor excluding instrument
calibration and expendable parts such as calibration gas, filters, batteries, etc... Equipment believed to be defective
should be returned to
ENMET within the warranty period (transportation prepaid) for inspection. If the evaluation by
ENMET confirms that the product is defective, it will be repaired or replaced at no charge, within the stated limitations,
and returned prepaid to any location in the United States by the most economical means, e.g. Surface UPS/FedEx
Ground. If an expedient means of transportation is requested during the warranty period, the customer is responsible for
the difference between the most economical means and the expedient mode.
ENMET shall not be liable for any loss or
damage caused by the improper use of the product. The purchaser indemnifies and saves harmless the company with
respect to any loss or damages that may arise through the use by the purchaser or others of this equipment.
This warranty is expressly given in lieu of all other warranties, either expressed or implied, including that of
merchantability, and all other obligations or liabilities of
ENMET which may arise in connection with this equipment.
ENMET neither assumes nor authorizes any representative or other person to assume for it any obligation or liability
other than that which is set forth herein.
NOTE: When returning an instrument to the factory for service:
Be sure to include paperwork.
A purchase order, return address and telephone number will assist in the expedient repair and return of your unit.
Include any specific instructions.
For warranty service, include date of purchase
If you require an estimate, please contact ENMET Corporation.
There are Return for Repair Instructions and Form on the last pages of this manual. This Form can be copied or used as
needed.
Manual Part Number
80003-123
April, 2013
Notes: