Elenco Circuit Maker Sound Plus 200 - Manual (Page 23)

-22-
Project #31
Press the press switch (S2) to play a recording followed by a song. If
you press the press switch before the song is over, music will stop. Adjust
the amount of light on the photoresistor (RP) to change the volume and
alter the tone. Wave your fingers over the photoresistor for some cool
sound effects.
Music in the Light
Project #30
Build the circuit on the left. It uses both jumper wires as
permanent connections. It also uses three (3) 2-snap wires
(“shorting bars”) under paper as shown.
Setup: Player 1 sets the “Quiet Zone” by placing three (3)
shorting bars under the paper on row A, B, C, or D, leaving only
one open. Player 2 must NOT know where the shorting bars are
located under the paper.
Both Player 1 and Player 2 are given 10 points. The object is for
Player 2 to guess the location of the “Quiet Zone” by placing their
shorting bar at positions W, X, Y, or Z. In the drawing on the left,
Player 1 sets up the “Quiet Zone” at position “C”. If Player 2
places their shorting bar across “Z” on the first try, the sounds
played mean they have not found the “Quiet Zone” and they lose
1 point. They have 4 tries to find the zone on each turn. Each
time sounds are made, they lose a point.
Player 2 then sets the A, B, C, D side and Player 1 starts
searching. Play continues until one player is at zero points and
makes sound during that player’s turn.
Quiet Zone Game
Sheet of paper
to hide position
of shorting bar
Shorting Bar for
A, B, C, or D
Shorting Bar for W, X, Y, or Z
CM-200_Manual_031914.qxp_CM-200_Manual_031914 4/2/14 12:04 PM Page 23