Datalogic Scanning QUICKSCAN QD2100 - Manual (Page 37)

Scanning Features
Product Reference Guide 29
Scanning Features
Scan Mode
Selects the scan operating mode for the reader. Selections are:
Trigger Single — When the trigger is pulled, scanning is activated until one of the fol-
lowing occurs:
- Scanning Active Time has elapsed
- a label has been read
- the trigger is released
This mode is associated with typical handheld reader operation: when the trigger is
pulled, scanning starts and the product scans until the trigger is released, or a label is read,
or the maximum
Scanning Active Time has elapsed.
Trigger Hold Multiple — When the trigger is pulled, scanning starts and the product
scans until the trigger is released or Scanning Active Time has elapsed. Reading a label does
not disable scanning. Double Read Timeout prevents undesired multiple reads of the same
label while in this mode.
Trigger Pulse Multiple — When the trigger is pulled, continuous scanning is activated
until Scanning Active Time has elapsed or the trigger has been released and pulled again.
Double Read Timeout 1 prevents undesired multiple reads of the same label while in this
mode.
Flashing — The reader flashes
1
on and off regardless of the trigger status. Flash rate is
controlled by Flash On Time and Flash Off Time . When Flash is ON the imager reads con-
tinuously. When Flash is OFF scanning is deactivated.
Always On — No trigger pull is required to read a barcode. Scanning is continually on.
If the trigger is pulled, the reader acts as if it is in Trigger Single Mode. Double Read
Timeout 1 prevents undesired multiple reads of the same label while in this mode.
Stand Mode — No trigger pull is required to read a barcode. Scanning is turned on au-
tomatically when an item is placed in reader’s field of view. If the trigger is pulled, the
reader acts as if it in single read mode.
Double Read Timeout 1 prevents undesired multiple
reads of the same label while in this mode.
Trigger Object Sense — This mode is similar to Stand Mode, except that a trigger pull
is required to activate the decoder.
1. Controlled by Flash On Time .