Datalogic Scanning QUICKSCAN QD2100 - Manual (Page 17)

Resetting the Standard Product Defaults
Product Reference Guide 9
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some
options and want the factory settings restored, scan the
Standard Product Default Set-
tings barcode below. This will copy the factory configuration for the currently active in-
terface to the current configuration.
The programming section lists the factory default settings for each of the menu com-
mands (indicated by shaded blocks and bold text) on the following pages.
NOTE
Factory defaults are based on the interface type. Configure the
imager for the correct interface before scanning this label.
Standard Product Default Settings