Label id: set individually per symbology – Datalogic Scanning QUICKSCAN QD2100 User Manual

Page 106

Data Editing

QuickScan® QD2100

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:

1. Scan the ENTER/EXIT barcode.

2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-

fix) by scanning the appropriate barcode in the section

Label ID Control on page 100

Reference

Figure 6

for Label ID positioning options if multiple identification features are

enabled.

3. Scan a barcode to select the symbology for which you wish to configure a custom Label

ID from the section

Label ID Symbology Selection, starting on page 101

4. Determine the desired character(s) (you may choose up to three) which will represent the

Label ID for the selected symbology.

5. Turn to the

ASCII Chart

on the inside back cover of this manual and find the equivalent

hex digits associated with your choice of Label ID. For example, if you wish to select an
equal sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to

Keypad, starting on page 291

and scan the barcodes representing the hex characters

determined. For the example given, the characters ‘3’ and ‘D’ would be scanned. More
examples of Label ID settings are provided in

Table 18

6. Scan the ENTER/EXIT barcode to exit Label ID entry.

7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.

This completes the steps to configure a Label ID for a given symbology.

Figure 6. Label ID Position Options

NOTE

If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.

Prefix

Suffix

Label ID

Bar Code Data

Aim ID