Programming – Datalogic Scanning QUICKSCAN QD2100 User Manual

Page 15

Setting Up the Imager

Product Reference Guide

USB Connection —

Connect the imager to a USB port on the terminal/PC using the

correct USB cable for the interface type you ordered. Reference

Figure 2

IBM Connection —

Connect the imager to the IBM port on the terminal/PC using the

correct IBM cable. Reference

Figure 2

Keyboard Wedge Connection —

The Keyboard Wedge cable has a ‘Y’ connection

from the imager. Connect the female to the male end from the keyboard and the remain-
ing end at the keyboard port at the terminal/PC. Reference

Figure 2

Figure 2. Other Interface Connections

Programming

The imager is typically factory-configured with a set of default features standard to the
interface type you ordered. After scanning the interface barcode from the

Interfaces

sec-

tion, you can select other options and customize your imager through use of the instruc-
tions and programming barcodes available in the corresponding features section for your
interface and also the

Data Editing

and

Symbologies

chapters of this manual.

NOTE

Specific cables are required for connection to different hosts. The
connectors illustrated above are examples only. Actual connectors
may vary from those illustrated, but the steps to connect the imager
remain the same.

ard

or...