Start sawing, Rt55 t4i operator’s manual – Ditch Witch RT55 User Manual
Page 96
RT55 T4i Operator’s Manual
Saw - 95
Operation
CMW
Start Sawing
1.
Adjust throttle to low idle.
2.
Lower backfill blade to ground.
3.
Move attachment speed/direction control to desired speed. SAW WILL TURN.
4.
Increase engine speed to full throttle.
5.
Slowly lower saw to trench depth.
6.
Raise backfill blade.
7.
Release parking brake.
8.
Push ground drive control forward to trenching speed.
IMPORTANT:
•
Before operating saw, check bits for free rotation. Tap bits lightly with a hammer and turn by hand. If
bits are stuck, remove and clean packed soil from bit block.
•
Work slowly and carefully.
•
Saw use is not recommended for soft, wet, or sticky soil conditions.
Incorrect procedures could result in death, injury, or property
damage. Learn to use equipment correctly.
NOTICE: Ensure that stabilizers are in contact with the ground while sawing. Failure to use
stabilizers correctly will damage equipment.
IMPORTANT:
•
Lower saw into softer material then move into harder or abrasive material. For example, lower
saw into dirt at shoulder before cutting across road.
•
If a curved trench must be cut, make a series of straight cuts.
IMPORTANT:
•
Ground drive speed/direction can be controlled with foot pedal or hand lever. When
trenching, set ground drive speed with hand lever. Use foot pedal to temporarily adjust
speed if digging conditions change for a short distance.
•