DaySequerra iLC2ST - Manual (Page 21)

iLC2ST User Manual
21
I/O Menu
Figure 6. I/O Menu screen display
The I/O Menu will allow you to tailor iLC2ST to suit your specific application.
Audio Input: Submenu for selecting the audio source and channel mapping.
Audio Output: Submenu for defining enabling and disabling the final limiter.
GPI 1 – 4: Changes the DayPart preset for each the four general-purpose inputs.
Clock Source: Defines where iLC2ST gets the timing signal.
a. Internal: iLC2ST’s internal clock. Define using Sync Source.
b. 1/2: iLC2ST will get timing from the 1/2 BNC Input.
c. 3/4: iLC2ST will get timing from the 3/4 BNC Input.
d. Internal: Processing is synchronized with the iLC2ST internal clock.
e. External: Processing is synchronized with the clock recovered from the External AES
Sync Input.
Sample Rate: If Clock Source is set to internal, defines what sample rate frequency 5
.15.1ST will use. (32.0, 44.1, 48.0, 88.2 or 96.0 kHz) Otherwise, the detected sample rate recovered
from the configured clock source is shown.
Audio Input Menu
Figure 7. Audio Input Menu screen display
NOTE: Unless your iLC2ST has the factory-installed HD/SDI I/O or Balanced Digital AES I/O modules
installed, your screen will differ from that above.